Outdoor PTZ Camera Professionals
Configuring port forwarding for your IP camera enables you to access your locally connected camera on the secure side of the router (via LAN) anywhere with internet at a different location (VIA WAN) through PC/Mac or Smartphone. It basically just forwards all traffic of your private camera to a public network. Port forwarding must be supported by […]
For H.265 IP camera, please apply the following preset code: Please use preset 250+251 (call PRESET 250, PRESET 251 successively) to initialize the lens over daytime. For H.264 IP camera, please apply the following preset code: Please use preset 189+204+20 (call PRESET 189, PRESET 204, PRESET 20 successively) to initialize the lens over daytime. Please use […]
Please first check the +/- polarity of RS485 twisted pair between the camera and DVR (or Joystick). The package comes with a white RS485 adapter that you can connect it to the orange and blue end coming out of the camera. In most cases, the blue end corresponds to +/A (positive) of the DVR’s RS485 port and the orange end corresponds to the -/B (negative) of the DVR’s […]
A home position is defined as a view where the camera will always return to when it no longer receives further commands from users. You will first have to setup your home position as a preset by following the guideline here: https://sunbatech.com//en/faq/setup-preset-views-sunba-ip-camera/ You will have to set this specific preset as a “park act”. This is also […]
Below is the preset control panel for IE/CMS and VMS. For other software or NVR, please refer to the instruction of the relevant tool. To setup presets, you have to first be familiar with the presets control panel. First, please go to a desired position use the direction panel. Then please enter the preset […]
Reset Lens Module in Device Config->Default (via Internet Explorer): Reset mainboard in OSD Menu (call preset 95) and use up and down key to select the restore default option. For certain models such as 507-20XB, the option may be on the 2nd page: Reset the lens module and the main board on VMS. please power cycle the camera […]
You will have to set patrol as a “park act”. This is also called “idle action”, meaning the camera will perform this action over and over if no further commands are received from users. Please first open the OSD menu of the camera by calling preset 95. The way to call preset depends on the […]
Note an IP camera can work standalone without a NVR, which is different from a traditional analog system where Digital Video Recorder is a must-have. In terms of recording, there are few options you can select from: A. Record to a computer. This requires you to have a dedicated computer that is on for 24/7. This means if […]
Please add the camera’s IP or domain to the trusted sites of your internet explorer browser as follows and try restarting the browser. Do NOT check the “require server verification (https:)” option.
In terms of the no video issues, there are plenty of possibilities: 1. Though we’ve tested the camera before shipment, it is likely the BNC wiring tail get damaged during transportation (distinctly chopped or squeezed). In this case, we will definitely send you a replacement cable. [this happens only rarely on 301 model, whose wiring tail […]
Spanish 
English 
Japanese 
German